Powerwalker SNMP Manager Instrukcja Użytkownika Pobierz pdf

1．

．．

． Overlook

SNMP I SNMP II (Only for 3-phase online UPS)

Ethernet port status LEDs:

100M LED (Green) Flash Port is operating at 100Mbit/s

Off Card is not connected to the network

10M LED (Yellow) Flash Port is operating at 10Mbit/s

Off Card is not connected to the network

2．

．．

． Installation and Connection

Follow below steps to install and connect the SNMP web card:

Step 1: Remove the cover of intelligent slot on the back panel of UPS and

retain the screws

Step 2: Slide the card into the open slot and secure with the screws from step

1. (see chart 2-1)

Chart 2-1

Refer to chart 2-2 for connecting the SNMP web card.

Step 3: Plug Ethernet cable to the Ethernet port (RJ-45) on the SNMP web

manager.

Step 4: Use one more Ethernet cable. Connect one end to the sensor port on the

SNMP web manager and the other end to the optional environmental monitoring

device.

Chart 2-2

SNMP Web Card Quick Guide

Ethernet port (10/100Base-T)

Sensor port

Golden finger: connects to

UPS slot

Ethernet port status LEDs

1 2

Strona 1

1．．．． Overlook SNMP I SNMP II (Only for 3-phase online UPS) Ethernet port status LEDs: 100M LED (Green) Flash Port is operat

3．．．． Configuration a) Please install SNMP web manager software in your PC. After software is installed successfully, the Installer will leave

Brak uwag

Powerwalker SNMP Manager Instrukcja Użytkownika